probanner

products

1-6609212-3 Single Port 8P8C Modular Jack ultra-thin RJ45 T/H Connector

  • Number of Ports: 1X1
  • Speed: RJ45 Without Magnetics
  • Application-Lan : NoN PoE
  • Latch: Down
  • LED: Without LED
  • Orientation : 90°Angle (Right)
  • Compatible Brand : Wurth
  • Mounting Type: Through Hole
  • Shielding: Shielded
  • Temperature: ﹣40 TO ﹢85
  • Product Length (mm): 18.40
  • Product Height (mm): 13.50
  • Product Width (mm): 15.80

  • Part Number:615008140121
  • Product Detail

    Contact Us

    Product Tags

    Similar Part No

    1-6609212-3 Single Port 8P8C Modular Jack RJ45 T/H Connector

    QQ截图20210819104925

    Categories  Connectors, Interconnects
     Modular Connectors - Jacks
    Application-LAN  ETHERNET(NoN POE)
    Connector Type  RJ45
    Number of Positions/Contacts  8p8c
    Number of Ports  1×1
    Applications Speed  RJ45 Without Magnetics
    Mounting Type  Through Hole
    Orientation  90° Angle (Right)
    Termination  Solder
    Height Above Board  13.40 mm
    LED Color  Without LED
    Shielding  Shielded
    Features  Board Guide
    Tab Direction  Down
    Contact Material  Phosphor Bronze
    Packaging  Tray
    Operating Temperature  -40°C ~ 85°C
    Contact Material Plating Thickness  Gold 6.00µin/15.00µin/30.00µin/50.00µin
    Shield Material  Brass
    Housing Material  Thermoplastic
    RoHS Compliant  YES-RoHS-5 WIth Lead in Solder Exemption

     

    Why does RJ connector appear false soldered RJ connector? We opened the RJ connector, and we saw that the solder joints were fake soldering, or the copper wire coil was broken. Why is this? It is fully testable on the RJ manufacturing end. But why are they leaked to the client application before they are discovered?
    The commonly used test equipment is LCR Meter, which is the inductance capacitance resistance tester. The shortcoming of this kind of test equipment is that it cannot measure DC resistance, only AC impedance, and the connection of the test line is long, and a relay is required, which invisibly increases the AC impedance value of the entire test line, so the AC impedance The test limit cannot be set too small, usually set to 5ohms, otherwise quite a lot of RJ connectors with good line connections will also be labeled as defective and cannot be manufactured.
    In this kind of test equipment, we can test the DC resistance, and the test limit can be set to 1.5ohms or even below 1ohm. In this way, any RJ connector with a slightly poor line connection can be typed out as a defective product Reduce the risk of leakage to the application side.

     

     


  • Previous:
  • Next:

  • 615008140121

    Write your message here and send it to us